Chronosync serial
![chronosync serial chronosync serial](https://technogog.com/wp-content/uploads/2009/06/windowslivewriterchronosync40-8c47chronosync11-2.jpg)
What, are they worried that people that don’t really own drobos are going to troll the forums talking about how to fix drobos? I can think of no reason why I would need to enter a serial number in order to access these forums. WTF? Are you kidding me? Why in God’s name should I be required to enter a serial number in order to access a help forum? That’s about the lamest thing I’ve ever seen. This time it wants me to put my *serial number* into the drobo system before I can have access. So I’m all ready to finally access the support forums but when I try to go into them I get still another screen denying me access. It asked me for my flickr ID which I thought was kind of cool and I put in thomashawk but got an error saying that they didn’t recognize my flickr ID. When I got into the system I checked off that I didn’t want their newsletter or other spamy sort of things and then went to upload my avatar (which I could not because I got an I/O device error on the same drobo).
#Chronosync serial registration#
But because I need the help I went through that registration process. Half the time the confirmation email ends up in your spam folder, sometimes you never get it, other times it takes an hour to get a simple email confirm. Personally I hate those kind of policies. The problem with drobo’s community forum though is that you can’t read it without first registering with the site by giving them your email address and clicking on a confirmation email back from them. If I reboot my drobo during the recovery process (because I think it is stuck and has hanged somehow) will I risk losing data. I often find that simple searches in community forums can often help you find the answers that you are looking for. So the first place that I like to try to go to start troubleshooting things like this is in community help forums. It looks like the drobo is still in the process of recovering (it says 22 hours remaining though and I feel like it should be further along as it’s been about 16 hours already) so I don’t want to try and reboot it or anything - but I can’t access any of my photos on this unit which is worrying me a little bit this morning. Unfortunately, when trying to access that folder I got the following error message: "The request could not be performed because of an I/O device error." And so that’s why you’re seeing this screenshot this morning instead of new photos from me. So this morning I got up as I always do and went to upload some photos to flickr (my to be uploaded photos are kept on this drobo). I love my drobos by the way and have been very happy with the job they do storing my photos. I had an estimated time of recovery of about 32 hours. But after I did this drobo began the process of re "protecting my data." The drobo messages reminded me that I could continue to use my files while this protection was going on but that I shouldn’t remove any drives during the process. So I took the drive out and reinserted it back into the drobo and the drobo recognized the drive again. When I went to check on the drobo in the dashboard though, in this case it was showing that a drive was not in that bay when there clearly was one.
![chronosync serial chronosync serial](http://lasopaaw782.weebly.com/uploads/1/2/5/3/125393018/714254762.gif)
Usually this means that the drive may have gone bad (I’ve replaced one already). So yesterday on one of my four drobos all of a sudden one of the lights went red.